CFD Simulation and Design of Non-Newtonian Fluid Polymer Grinding Pump Under Turbulent Flow
The performance of the grinding pump, a device for crushing and stretching conventional polymers, is mainly affected by its stage number, diameter, and tooth count. In this paper, Fluent software was utilized, employing the Eulerian model in conjunction with non-Newtonian fluid models (such as the p...
שמור ב:
| Main Authors: | , , , , , , |
|---|---|
| פורמט: | Article |
| שפה: | אנגלית |
| יצא לאור: |
MDPI AG
2025-05-01
|
| סדרה: | ChemEngineering |
| נושאים: | |
| גישה מקוונת: | https://www.mdpi.com/2305-7084/9/3/49 |
| תגים: |
הוספת תג
אין תגיות, היה/י הראשונ/ה לתייג את הרשומה!
|
| סיכום: | The performance of the grinding pump, a device for crushing and stretching conventional polymers, is mainly affected by its stage number, diameter, and tooth count. In this paper, Fluent software was utilized, employing the Eulerian model in conjunction with non-Newtonian fluid models (such as the power-law model and Bingham plastic model) and turbulence models (like the k-ε model) to establish a model for CFD (Computational Fluid Dynamics) simulations. These simulations analyzed the turbulence characteristics of non-Newtonian fluids in grinding mixing pumps, as well as the basic performance of the pumps, including pressure, velocity, viscosity, and volume fraction distributions. The effects of different structural parameters (stage number, pump diameter, and tooth count) on the instant dissolving effect of polymers were compared, and the optimal structure was determined. Based on pressure profile, velocity profile analysis, and polymer distribution simulation results, the optimal grinding mixing pump was found to have three stages, with a diameter of d = 140 mm and 60 teeth yielding the best grinding effect. Increasing the stage number and pump diameter can improve the grinding and mixing effect, but an excessively large pump diameter can reduce it. Changes in tooth count have a minor impact on viscosity but affect distribution uniformity. |
|---|---|
| ISSN: | 2305-7084 |