Combination of Acid and Base Activation of Montmorillonite Clay and Its Impact on the Basic Blue-41 Removal Properties: Regeneration and Single Batch Design
The treatment with an alkali (sodium hydroxide) solution of acid-activated montmorillonite clay minerals resulted in a reduction in specific surface area. However, a significant enhancement in the removal of basic blue-41 dye solution was achieved compared to acid-activated samples only (first step...
Saved in:
| Main Authors: | , , , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
MDPI AG
2025-07-01
|
| Series: | Inorganics |
| Subjects: | |
| Online Access: | https://www.mdpi.com/2304-6740/13/7/228 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | The treatment with an alkali (sodium hydroxide) solution of acid-activated montmorillonite clay minerals resulted in a reduction in specific surface area. However, a significant enhancement in the removal of basic blue-41 dye solution was achieved compared to acid-activated samples only (first step of activation) and to the raw montmorillonite clay. The obtained products were characterized using different techniques. The results indicated that the acid-activated montmorillonites exhibited different physicochemical properties than the starting raw montmorillonite, with a reduction in the cation exchange capacity and improvements in the specific surface area (from 5 m<sup>2</sup>/g to 274 m<sup>2</sup>/g) and total pore volume (from 0.031 cm<sup>3</sup>/g to 0.450 cm<sup>3</sup>/g) due to the formation of the amorphous silica phase. However, the treatment with NaOH solution was accompanied by significant reductions in the specific surface area (from 274 m<sup>2</sup>/g to 18 m<sup>2</sup>/g) and total pore volume (from 0.450 cm<sup>3</sup>/g to 0.02 cm<sup>3</sup>/g) due to the dissolution of the formed amorphous silica phase, as confirmed through <sup>29</sup>Si MAS NMR and FTIR techniques. In addition, the SiO<sub>2</sub>/Al<sub>2</sub>O<sub>3</sub> molar ratios were close to those of the starting montmorillonite clay. The removal of the cationic basic blue-41 was optimized under different conditions, such as different initial concentrations, adsorbent doses, and pHs of the dye solution. The maximum removal capacities of acid-activated clays were in the range of 45 mg/g to 80 mg/g and decreased with the extent of the acid activation process. However, the capacities were enhanced after NaOH treatment and reached values in the range of 80 to 120 mg/g. Enhancing the surface area had less of an impact on the materials’ removal ability. The obtained materials performed well in seven adsorption–regeneration cycles, showing a 70% reduction in removal effectiveness. |
|---|---|
| ISSN: | 2304-6740 |