Application of Blade-Tip Sensors to Blade-Vibration Monitoring in Gas Turbines

QR Code

Application of Blade-Tip Sensors to Blade-Vibration Monitoring in Gas Turbines

None

Saved in:

Bibliographic Details
Main Authors:	Szczepanik, Ryszard, Przysowa, Radosław, Spychała, Jarosław, Rokicki, Edward, Kaźmierczak, Krzysztof, Majewski, Paweł
Format:	Electronic Book Chapter
Language:	English
Published:	IntechOpen 2012
Subjects:	Physical Sciences, Engineering and Technology
Online Access:	https://www.intechopen.com/chapters/26042
Tags:	Add Tag No Tags, Be the first to tag this record!

Similar Items

Approximation of the Profile of Gas Turbine Engine Blades
by: M. E. Soloviev, et al.
Published: (2024-03-01)

MODERNIZATION OF VANES AND BLADES OF GAS TURBINES WITH HONEYCOMB SEAL
by: V. T. Buglaev, et al.
Published: (2003-06-01)

EVALUATION OF OPERATIONAL EFFICIENCY OF DIFFUSION COATINGS FOR TURBINE BLADES OF CONTEMPORARY GAS TURBINE ENGINES
by: E. G. Ivanov, et al.
Published: (2016-11-01)

A Comparison of a Three Blade and Five Blade Wind Turbine in Terms of the Mechanical Properties Using the Q-Blade Software
by: Othman K. Zidane, et al.
Published: (2024-09-01)

New Non-Destructive Methods of Diagnosing Health of Gas Turbine Blades
by: Błachnio, Józef, et al.
Published: (2011)

Vacuum-plasma protective coating for turbines blades.
by: O. V. Sagalovych, et al.
Published: (2020-04-01)

Influence of impurities contained in fuel and air on sulfide corrosion of turbine blades of the gas turbine engine
by: V. M. Samoylenko, et al.
Published: (2023-03-01)

BTT & RFLB - THE OPTIMUM SET FOR STEAM TURBINE BLADES MONITORING
by: Miroslav Balda
Published: (2018-12-01)

Crack Location in Wind Turbine Blades Using Vibration Signal and Support Vector Machine
by: Perla Y. Sevilla-Camacho, et al.
Published: (2025-04-01)

Damageability of Gas Turbine Blades – Evaluation of Exhaust Gas Temperature in Front of the Turbine Using a Non-Linear Observer
by: Błachnio, Józef, et al.
Published: (2011)

Repair of Turbine Blades Using Cold Spray Technique
by: Ogawa, Kazuhiro, et al.
Published: (2011)

Reuse of Retired Wind Turbine Blades in Civil Engineering
by: Xuemei Yu, et al.
Published: (2025-07-01)

Development of a Simulation Model for Blade Tip Timing with Uncertainties
by: Kang Chen, et al.
Published: (2025-05-01)

The method of calculating the minimum creep rate of turbine blades of gas turbine engines based on the degradation of the alloy microstructure
by: Y. V. Petrov, et al.
Published: (2023-03-01)

A State-of-the-Art Review of Wind Turbine Blades: Principles, Flow-Induced Vibrations, Failure, Maintenance, and Vibration Suppression Techniques
by: Tahir Muhammad Naqash, et al.
Published: (2025-06-01)

Single-Sensor Impact Source Localization Method for Anisotropic Glass Fiber Composite Wind Turbine Blades
by: Liping Huang, et al.
Published: (2025-07-01)

ESTIMATION OF THE STRESS-STRAIN STATE OF A GAS TURBINE ENGINE BLADES by LASER OPTICAL-ACOUSTIC METHOD
by: O. N. Karpenko, et al.
Published: (2016-11-01)

Investigation on Designing and Development of a Selective Laser Melting Manufactured Gas Turbine Blade—Proof-of-Concept
by: Mihaela Raluca Condruz, et al.
Published: (2025-05-01)

Modal Passport Concept for Enhanced Non-Destructive Monitoring and Diagnostics of Wind Turbine Blades
by: Aleksey Mironov, et al.
Published: (2025-04-01)

Effect of Blade Profile on Flow Characteristics and Efficiency of Cross-Flow Turbines
by: Ephrem Yohannes Assefa, et al.
Published: (2025-06-01)

Operational Modal Analysis for Crack Detection in Rotating Blades
by: Jarosław BEDNARZ
Published: (2017-01-01)

Application of Piezofilms for Excitation and Active Damping of Blade Flexural Vibration
by: Ludek PESEK, et al.
Published: (2015-01-01)

Modelling Friction Contacts in Structural Dynamics and its Application to Turbine Bladed Disks
by: Firrone, Christian Maria, et al.
Published: (2011)

ANALYSIS OF MODERN TURBINE ENGINES WORKING SURFACE LAYERS BLADES WORK CONDITIONS
by: М. A. Petrova, et al.
Published: (2016-11-01)

The method of estimating the durability of the coating on the turbine blades from alloys ISO and ISSN
by: R. G. Ravilov, et al.
Published: (2016-11-01)

Effect of Deposits on Micron Particle Collision and Deposition in Cooling Duct of Turbine Blades
by: Shihong Xin, et al.
Published: (2025-05-01)

Synergistic Noise-By-Flow Control Design of Blade-Tip in Axial Fans: Experimental Investigation
by: Bianchi, Stefano, et al.
Published: (2012)

Non Contact Measurement System with Electromagnets for Vibration Tests on Bladed Disks
by: Firrone, Christian Maria, et al.
Published: (2012)

Glaucoma Surgery with Fugo Blade
by: Singh, Daljit, et al.
Published: (2011)

Small Horizontal Wind Turbine Design and Aerodynamic Analysis Using Q-Blade Software
by: Othman K. Zidane, et al.
Published: (2023-10-01)

EXPERIMENTAL AND NUMERICAL STUDY OF CONTROLLED FLUTTER TESTING IN A LINEAR TURBINE BLADE CASCADE
by: Václav Sláma, et al.
Published: (2018-12-01)

Effect of recycled turbine blade powder and fibres on mechanical and life cycle properties of mortar
by: Yutao Guo, et al.
Published: (2025-12-01)

Aerodynamic response of a blade cascade to torsional excitation of one blade at subsonic and transonic velocities
by: David Šimurda, et al.
Published: (2025-06-01)

Two blades of grass : rural cooperatives in agricultural modernization /
Published: (1971)

A comprehensive review of existing erosion protective coatings and practices for wind turbine blade surfaces
by: Alnassir Atheer, et al.
Published: (2025-01-01)

Wind Turbine Blade Defect Recognition Method Based on Large-Vision-Model Transfer Learning
by: Xin Li, et al.
Published: (2025-07-01)

Blade optimal design parameters determination
by: N. T. Surashov, et al.
Published: (2022-09-01)

Turn height calculation for spiral blade
by: V. A. Nikolayev
Published: (2023-07-01)

Improving the Efficiency of an Eddy Current Sensor Measuring the Thickness of a Heat-Resistant Metal Film of Turbine Blades During Its Deposition in Vacuum
by: В. Хуей, et al.
Published: (2022-07-01)

Modeling the critical rotation speed of a bladed rotor with bent blades in a circulation mixer of feed mixtures
by: T. M. Kovaleva, et al.
Published: (2024-09-01)